VTech NG-Series
Connect your VTech NG-Series hotel phone to FS PBX and set up one-touch speed-dial buttons. Select vtech/NG-Series for these models:
| Family | Models |
|---|---|
| Corded | NG-S3211, NG-S3211W, NG-S3212, NG-S3311 |
| Cordless | NG-S3111, NG-S3112, NG-S3411, NG-S3411W, NG-S3412 |
This setup supports one extension per phone. Analog NG-A models are not covered by this guide.
Assign the device
- Open Devices in the correct account and add the phone's MAC address.
- Select vtech/NG-Series as the Device Template.
- Assign the extension to Line 1.
- Check the SIP server, outbound proxies, transport, and port in Advanced Line Settings.
- Save the device.
Point the phone at FS PBX
Open the phone's web interface and go to Servicing → Provisioning. Enter this Server URL, replacing pbx.example.com with your PBX hostname:
https://pbx.example.com/prov/{mac}.cfg
Keep {mac} exactly as written. The phone fills in its own MAC address, so you can use the same URL for every phone.
Enter the account's provisioning username and password in Server Authentication Name and Server Authentication Password. You can find these as http_auth_username and http_auth_password under the provision category in Domain Settings.
Save and restart the phone. Once it shows as registered, make an incoming and outgoing test call.
Configure speed dials
Choose Speed Dial for the phone's programmable buttons. BLF, line appearances, and monitored call parking are not supported by this setup. Speed-dial buttons call a number but do not show whether an extension is busy.
- Open the device's Function Keys tab, or assign a Key Template for a shared layout.
- Choose the button position and set Type to Speed Dial.
- Select the extension or enter the number to dial.
- Save, then select Sync from the device's action menu.
- Press the button on the phone to check that it calls the intended number.
| Positions | Use |
|---|---|
| 1–10 | Base speed-dial buttons, where fitted |
| 13 | Cordless handset Service button on NG-S3112 and NG-S3411/NG-S3411W/NG-S3412 |
| 14 | Cordless handset Emergency button on those same models |
For NG-S3111, follow VTech's instructions for handset speed dials; they cannot be configured through FS PBX.
To remove a button assignment, clear its value or select N/A, then save and sync the phone.
Optional settings
To change these preferences for an account, open Domain Settings and use the provision category. For one phone, use its device settings. Enable each setting you want to apply, then save and sync the affected phones.
| Preference | Setting name | Value |
|---|---|---|
| Time zone | vtech_time_zone | For example, America/New_York |
| Voicemail access number | voicemail_number | *97 by default |
| Time server | ntp_server_primary | pool.ntp.org by default |
| Phone administrator password | admin_password | Up to 15 letters and numbers |
| VLAN tagging | vtech_vlan_wan_enable | 1 to enable, 0 to disable |
| Voice VLAN | vtech_vlan_wan_id | Your network's VLAN ID |
| VLAN priority | vtech_vlan_wan_priority | 0–7 |
To turn off VLAN tagging, set vtech_vlan_wan_enable to 0 and leave that setting enabled.